3D-Show

Extra > 3D-Show

Save Hidden Model, Stepsize

Set the maximum number of items for the computation of the hidden line image. If there are more items, the image is divided into vertical strips. The hidden line image is then computed for each of these strips.

This setting is applicable only for the 3D-Show application.

Grid Creating Holes/Profiles

When enabled (default), a grid is displayed when holes or profiles are created.

This setting is applicable only for the 3D-Show application.

Hull Lines Orthogonal Plate

When enabled, the hull line be displayed when an orthogonal plate is created. This setting is disabled by default.

This setting is applicable only for the 3D-Show application.

Hull Lines Slanting Plate

When enabled (default), the hull line will be displayed when a slanting plate is created.

This setting is applicable only for the 3D-Show application.

Intersections Viewing Depth

Set the viewing depth at intersections. Construction is visible if it lies in the area defined by the depth value in front of and behind the cross section. A positive value is required.

This setting is applicable only for the 3D-Show application.

3D-Show Arcs

All arcs within holes and in plates are converted into a number of vectors. This setting defines the maximum deviation of the presentation in relation to the arc. The value must lie between 0.5 and 10 mm.

This setting is applicable only for the application 3D-Show, and only if the Presentation > Plates > Show arcs setting in the System Management application is enabled.

Important: Defining a low value can slow down the 3D-Show application significantly.