Content

Production > Plate Cutting Data > Text > Content

Show Texts Along Marking Lines

By default part numbers are visible at the centre of marking lines. This feature can be disabled with this setting.

Marking And Flange Side, Text

Swap automatically the text that indicates the side where a marking, flange, or corrugated stiffener has been placed. During the mirroring of the part, the texts defined here are swapped so that they indicate the correct side. Disable this setting by typing in "off".

Marking Texts, This/Other Side

Set the abbreviations used for markings to indicate this side, other side, or both sides. Disable this setting by typing in "off".

Mirrored Text Prefix

If a text is located entirely outside the contour, it is mirrored inside the contour. This setting defines a text prefix that is added to the mirrored text.

Mirrored Text Postfix

If a text is located entirely outside the contour, it is mirrored inside the contour. This setting defines a text postfix that is added to the mirrored text.

Prefix Marking At Centre Line

Define a prefix text for markings at the centre line. The CL Margin For Text On Marking setting can be used to set the distance of the marking to the centre line. Only markings within this distance can receive this prefix.

Postfix Marking At Centre Line

Define a postfix text for markings at the centre line. The CL Margin For Text On Marking setting can be used to set the distance of the marking to the centre line. Only markings within this distance can receive this postfix.