With this configuration the resulting DXF/DWG is as closely as possible to the drawing on the screen. No special filtering is applied. The "general" configuration consists of the following files:
- dxf-general.cfg
- tablayerexpgeneral.dat
- tabdashexpgeneral.dat
- tabfontexpgeneral.dat
- tablayerimpgeneral.dat
- tabdashimpgeneral.dat
- tabfontimpgeneral.dat
in the %ncghelps%\dxf directory.
If this configuration is used for exporting from CADMATIC Hull and for importing the exported drawing back into CADMATIC Hull all elements will be again in the same fragments.
If however this configuration is used only for importing DXF/DWG files with unknown layer, line type arrangements, Tworuns should be set to yes and the %scanlayer% and %scanlinetype% variables can designate respectively the same file as %tablayer% and %tabdash% do.