Introduction

The CADMATIC Hull Benchmark is designed to evaluate the general performance of your CADMATIC Hull setup in a networked environment. By running the three tests that comprise the Benchmark you can evaluate how your hardware and network setups perform against the reference values that reflect average performance. The tests take a certain amount of time to run depending on various factors such as hardware, network and virus scanner.

The performance of CADMATIC Hull on a customer site depends on various factors. The Benchmark is designed to help you identify the possible causes for low performance. If the test results indicate that your setup runs noticeably slower than the given reference values, the recommendations in Recommendations for Improving Performance may help you to improve the performance of your setup.

We have created a Hull project with a fully engineered block that the Benchmark is designed to be performed on. The project is available for download on the Cadmatic Support Portal.

Two of the tests included in the Benchmark are run in the Hull 3D-Contek application. One test is run with the ATTO Disk Benchmark software, which is available for download on the Cadmatic Support Portal along with the test project.

Download the test project and the ATTO Disk Benchmark software from the CADMATIC Customer Support Portal's Downloads / Supporting materials / CADMATIC Hull Benchmark section.

These instructions are available for download in the same location as a PDF document (CADMATIC Hull Benchmark.pdf).