Shape definition of hole in lug

It is possible to add holes to lugs. This is done by including hole lines in the contour definition part of the lug type file using the HOLE command.

The hole will be shown in the drawing, included in the coded part (DXF file), and visible in Hull Viewer.

The type of the hole line (line, point, arc) must be indicated by appending L, P, or C to the HOLE command (LHOLE, PHOLE, CHOLE).

Note: A lug type file can only have one hole definition.

The following rules apply:

• The hole lines must be placed directly before or after the COLL lines.
• LHOLE must have the same starting and end point (see the LHOLE line in the example below).
• There can be a maximum of 60 contour lines, including the hole lines.

Example:

1 0
0
LET V1=-1
LET V2=4
LET V3=3
LET V4=2
LET V5 = H1/V2*V4TR8+B1+R7
LET V6 = V5CR8
LET V7 = H1/2SR8
L H1/V2 B1 H1/V2+V6 B1+RD+V5
L H1/V2+V6 B1+RD+V5 H1/V2*V3+V6 B1+RD+V5-V7
L H1/V2*V3+V6 B1+RD+V5-V7 H1/V2*V3 B1
L H1/V2*V3 B1 H1/V2 B1
LHOLE H1/V4 30 H1/V4 30
CHOLE H1/V4 40 -10
PHOLE H1/V4 50
CHOLE H1/V4 40 -10
PHOLE H1/V4 30
LCOLL H1/V2 B1 H1/V2+V6 B1+RD+V5
LCOLL H1/V2+V6 B1+RD+V5 H1/V2*V3+V6 B1+RD+V5
LCOLL H1/V2*V3+V6 B1+RD+V5 H1/V2*V3 B1
LCOLL H1/V2*V3 B1 H1/V2 B1 LGPR
E H1/V2 B1 H1/V2*V3 B1+RD+V5
W PL 0 Lug type 700B
D TY "TYPE 700B-PF" R8 "JIG Plane angle: "
P TH GR-A  0
P TH AH36  0
P TH 316LN 0
P TH ST42  0
P TH ALM   0