Structural design user training tutorial

Welcome to the online version of CADMATIC Hull's Structural Design User Training. This training is based on the verbal training normally given by one of NCG's trainers. This tutorial follows it as much as possible.

To conduct this training by yourself, the following requirements are needed:

This online tutorial document
The training project (in case you do not have this, please contact our Support Department)
A printed version of the Sheet_drawing_108_1.tiff and the Sheet_drawing_108_2.tiff, which can be found in the 'training14' project directory.

This online training is built up using the following setup:

Each training step is explained in a so-called 'Topic' which starts with a picture (select the topic link 'Start situation') of what you should see on your screen after the accompanied drawing is opened ("OPEN DRAWING"). The name of the topic is the same as the drawing (view) to be opened.
Next a short description on what is going to be performed in the training step is given.
The 'Overview of actions' lists the individual actions to be taken to get the desired result (which can be viewed by selecting the topic link 'End situation').
In case a certain action has not been explained/described yet in one of the previous training steps, the action is marked as a topic link which will be displayed when selecting this topic link. To return to the 'Overview of actions', you can use one of the 'arrow' icons which can be found at the top and at the bottom of the topic.
When the action has already been explained/described in one of the previous training steps, but should be used in a slightly different way or with other values, this is indicated by the sign at the end of the action. This means that this action is further described in the 'Additional description of actions', which also contains a reference to the 'original' topic describing the same action.
In section "Make block available for dashed" we need block 109. That block is the mirrored block from 108.