Systems in integration

In CADMATIC Outfitting, every object belongs to a System. The following Systems are automatically created by CADMATIC Outfitting when Plant Modeller is started. CADMATIC Hull objects are assigned to these Systems when they are imported.

  • Hull Plates, ID number 6000
  • Hull Profiles, ID number 6001
  • Hull Shellframes, ID number 6002
  • Hull Brackets, ID number 6003
  • Hull Foundations, ID number 6004
  • Hull Shell plates, ID number 6005
  • Hull Hull lines, ID number 6006
  • Hull HoleRequests, ID number 6007
  • Hull Compartments, ID number 6093
  • Hull Fire zones, ID number 6094
  • Hull Flooded volumes, ID number 6095
  • Hull Outfit areas, ID number 6096
  • Hull Super blocks, ID number 6097
  • Hull Blocks, ID number 6098
  • Hull Sub blocks, ID number 6099
  • Hull Insulation, ID number 6008
  • Hull Welds, ID number 6092

Note: If you have some other System that uses these IDs, when you start using CADMATIC Hull integration the relevant objects are assigned to these System IDs even if they already include other objects.

These Systems also have a special attribute Source Application which you cannot assign to any other System. This attribute tells CADMATIC Outfitting from which peer application the System has come.

You cannot use any of these Systems in CADMATIC P&ID.