Fillet corners

Home tab > Modify group > Fillet, FILLET

Fillet the corner of two lines or arcs or the corners of a polyline.

Do the following:

1. If you want to change the radius of the fillet, do the following:

   1. On the command line, enter Radius.

   2. Enter the radius.

2. If you want to change the trimming of the fillet, do the following:

   1. Enter Trim.

   2. If you want to connect the fillet to the lines, enter Yes.

   3. If you want to keep the original corner visible, enter No.

3. If you want to fillet all the corners of a polyline, do the following:

   1. Enter Polyline.

   2. Select the polyline whose corners you want to fillet.

4. If you want to fillet the corners between two lines or arcs, do the following:

   1. Select the line or arc that you want to fillet. If the lines or arcs cross each other, select the object on the side that you want to keep.

   2. Select the other line or arc. If the lines or arcs cross each other, select the object on the side that you want to keep.

The program extends the lines if necessary and connects them with a fillet according to your definitions.

Remove a fillet

Do the following:

1. Select Edit > Erase.

2. Select the arc that you want to remove that connects the objects.

3. If you want to, you can extend the lines by stretching them or selecting Edit > Join > Join corner and selecting the objects.

If you want to remove one or more fillets from a polyline, enter 0 as the radius and fillet the corners of the polyline again according to the instructions above.

Related Topics

• Chamfer corners