Insert terminal blocks and connectors

Let's insert terminal blocks for the control system +CS1 and the distribution board +MCC1. Let's also insert device connectors for B1.

Do the following:

  1. In the Symbols window, select Terminals and insert the terminal block symbol. The Insert terminal block / connector dialog opens.

  2. Define the following for the control system +CS1:

    • ID – X1

    • Number – 1

    • Number of symbols and insertion mode – Space evenly, 16

  3. Indicate the insertion point for the first terminal block (= location).

  4. Indicate the connector number inside the location boundaries, and click.

  5. Indicate the insertion point for the second terminal block (space between terminal blocks 6 raster points = 6 x 3.5 mm.

  6. Move the terminal blocks (5–16) according to the example drawing:

    1. Select the terminal blocks to be moved (5-16) in the selection dialog.

      Note: Select the terminal blocks from bottom to the top.

    2. Right-click and select Move.

    3. Indicate the new location.

  7. Insert the rest of the control system +CS1 terminal blocks as described.

  8. Insert the distribution board +MCC1 terminal blocks X11:10–14 and 17–18 as described.

    1. Define the following:

      • ID – X11

      • Number – 10

      • Number of symbols and insertion mode – One by one, 5

    2. Insert terminal blocks 17 and 18.

      Tip: Align the X11 terminal blocks with the +CS1 terminal blocks.

  9. Insert B1 device connectors - and +: first number -/+.
Previous Next