Process And Job Code Numbers
Logistics > Process And Job Code Numbers
Define process codes and job codes used in various types of construction. The system will use the process and job numbers defined in the table if all of the set conditions are met.
These settings are valid only when Use Numbers is selected in Settings > Process/Job Code Method. This is the default setting.
The type of construction is determined as follows.
- One of the following parts: plate, bracket, shell frame, lugs, profile type. The available profile types are the standard available types (ST, HP, HG etc.), and user defined types
- Optionally, the selected part can be combined with one or more of the following parts: flange, knuckle, bent (only for shell plates and shell frames), corrugated stiffener, bevel, taper.
Note: The Bent property can only be set for combinations of shell plates and shell frames.
Process codes for shell plates
The process code of a shell plates depends on its curvature properties. See the table below for the properties that should be set for shell plates with different curvatures.
| Curvature Type | Bent | Knuckle | Flange |
|---|---|---|---|
| Flat | |||
| Curved – Conical | X | ||
| Curved – Elliptic Paraboloid | X | X | |
| Curved – Hyperbolic Paraboloid | X | X | X |