Principal particulars
The particulars of a ship must be defined also in CADMATIC Hull. These settings are defined in System Management settings Main Particulars and Project Drafts. There are certain key physical characteristics that are needed for the classification of a vessel via OCX. Since Hull and OCX use different variable names, the following tables show how the names of these particulars correspond.
Required particulars
The distance values are given in mm.
|
Hull UI name |
OCX name |
|---|---|
| Block Coeff. Scantling Draft | BlockCoefficient |
|
Breadth Moulded |
MouldedBreadth |
|
Depth Moulded |
MouldedDepth |
| Fore Peak Freeboard Waterline | FP_Pos |
| Length Between Perpendiculars | Lpp |
| Loadline Length | FreeboardLength |
| Maximum Service Speed | DesignSpeed |
|
Rule Length |
RuleLength |
| Scantling Draft | ScantlingDraught |
Optional particulars
The distance values are given in mm.
|
Hull UI name |
OCX name |
|---|---|
| Aft Peak Freeboard Waterline | AP_Pos |
| Bilge Keel | hasBilgeKeel |
| Deadweight | hasDeadweightLessThan |
| Deepest Equilibrium | DeepestEquilibriumWL |
| Depth at Freeboard Deck | FreeboardDeckHeight |
|
Depth At Top Continuous Member |
ZPosOfDeck |
| Freeboard Type | freeboardType |
| Heavy Ballast Draft | HeavyBallastDraught |
|
Length of Waterline |
LengthOfWaterline |
|
Minimum Ballast Draft |
MinimumBallastDraught |
|
Normal Ballast Draft |
NormalBallastDraught |
| Number of Decks Above | numberOfDecksAbove |
|
Slamming Draft Empty Fore Peak |
SlammingDraughtEmptyFP |
|
Slamming Draft Full Fore Peak |
SlammingDraughtFullFP |
|
Speed Factor Cavitation |
SpeedFactor |
|
Upper Deck Area |
UpperDeckArea |
|
Vertical Distance Base-Deck |
ZPosDeckline |
|
Water Plane Area |
WaterPlaneArea |